Home » Automotive Guide » Four “misunderstandings” about lubricants

Four “misunderstandings” about lubricants

Posted by: AutoMotive 2021-10-21 Comments Off on Four “misunderstandings” about lubricants

Car lubricants are used very frequently during maintenance. In addition to protecting the engine and reducing the number of oil changes, high-quality lubricating oil can also save gasoline costs. At the same time, be careful not to cause car breakdowns due to improper use of lubricating oil. The “improper” use method generally stems from the four “misunderstandings” of car friends about lubricating oil.
Misunderstanding 1: The amount of lubricating oil should be controlled between the upper and lower scale lines of the oil dipstick. Because too much lubricating oil will escape from the gap between the cylinder and the piston into the combustion chamber and burn to form carbon deposits. These coke deposits will increase the compression ratio of the engine and increase the tendency of knocking; the coke deposits in the cylinder are red hot and easily cause pre-ignition. If they fall into the cylinder, it will aggravate the wear of the cylinder and piston, and will also accelerate the pollution of the lubricating oil. Secondly, too much lubricating oil increases the stirring resistance of the crankshaft connecting rod and increases fuel consumption.
Misunderstanding 2: When the lubricating oil turns black, it is time to change the oil. This understanding is not comprehensive. For lubricating oils that have not been added with a quiet dispersant, the darkening of the color is indeed a sign of severe deterioration of the oil, but the lubricating oil used in modern cars is generally added with a quiet decomposer. This cleanser will wash off the rubber film and black carbon deposits adhering to the piston and disperse it in the oil to reduce the generation of high-temperature deposits in the engine. Therefore, the color of the lubricating oil will easily turn black after a period of use, but at this time The oil has not completely deteriorated.
Misunderstanding 3: Lubricating oil is often added and not changed. It is correct to check the lubricating oil frequently, but only supplementing without replacing can only make up for the lack of oil quantity, but it cannot fully compensate for the loss of lubricating oil performance. During the use of lubricating oil, the quality will gradually decline due to pollution, oxidation and other reasons, and at the same time there will be some consumption, which reduces the quantity.
Misunderstanding 4: Additives are useful. Real high-quality lubricants are finished products with a variety of engine protection functions. The formula contains a variety of additives, including anti-wear agents, and the lubricant* pays attention to the balance of the formula to ensure sufficient performance Play. Adding other additives by oneself will not only not bring additional protection to the vehicle, but it will easily react with the chemical substances in the engine oil, resulting in a decline in the overall performance of the engine oil.

Link to this article:Four "misunderstandings" about lubricants

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.:Cnc Machining,Thank!^^